LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Mode Door Replacement - Lower >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
    2. Fig 1: View Of Mode Actuator
    GM826791Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector (3) from the mode actuator (4).
  3. Remove the screws from the mode actuator (4).
  4. Remove the mode actuator (4) from the HVAC module assembly (1).
  5. Remove the wiring harness from the air distribution housing (1).
    6. Fig 2: View Of Air Distribution Housing (Visteon)
    GM826798Courtesy of GENERAL MOTORS CORP.
  6. Remove the screws from the air distribution housing (1).
  7. Remove the air distribution housing (1) from the HVAC module assembly (2).
    8. Fig 3: Mode Door (Visteon)
    GM826792Courtesy of GENERAL MOTORS CORP.
  8. Remove the mode door (2) from the air distribution housing (1).
scientia non olet · About LEMON Manuals