LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> HVAC Module Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: HVAC Module
    GM810832Courtesy of GENERAL MOTORS CORP.
  1. If replacing the HVAC module, transfer the components from the old HVAC module as necessary.
  2. Install the HVAC module assembly (2) to the vehicle (1).
    3. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the nuts (4) to the HVAC module assembly (2).

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  4. Install the bolts (4) to the HVAC module assembly (2).

    Tighten:  Tighten the bolts to 4 N.m (35 lb in).

  5. Connect the electrical harnesses and the ground connections.
  6. Install the HVAC module drain hose.
  7. Install the instrument panel carrier. Refer to Instrument Panel Carrier Replacement .
  8. Install the accumulator. Refer to Accumulator Replacement .
    9. Fig 2: Identifying Heater Hose To Heater Core Fittings
    GM362171Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Firmly push the quick connect onto the heater core pipe until you hear an audible click.
  9. Install the surge tank outlet hose to the heater core.
  10. Pull the surge tank outlet hose to ensure the connection.
  11. Install the inlet heater hose to the heater core.
    IMPORTANT: Firmly push the quick connect onto the heater core pipe until you hear an audible click.
  12. Pull the inlet heater hose to ensure the connection.
  13. Fill the engine coolant. Refer to Draining and Filling Cooling System .
scientia non olet · About LEMON Manuals