Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new sealing washers. Refer to Sealing Washer Replacement .
- Install the evaporator tube (4) to the body retaining clip (3).
- Install the evaporator tube (4) to the evaporator.
- Install the evaporator tube nut (1) to the evaporator.
Tighten: Tighten the nut to 16 N.m (12 lb ft).
- Install the evaporator tube (3) to the condenser (1).
- Install the evaporator tube nut (2) to the condenser (1).
Tighten: Tighten the nut to 16 N.m (12 lb ft).
- Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
- Leak test the fittings of the components using the J 39400-A .
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.