LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Discharge Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  2. Disconnect the electrical connector from the A/C recirculation switch.
  3. Remove the A/C recirculation switch from the A/C discharge hose.
    4. Fig 1: Discharge Hose & A/C Compressor
    GM798935Courtesy of GENERAL MOTORS CORP.
  4. Remove the discharge hose bolt (6) from the A/C compressor (4).
  5. Remove the discharge hose (5) from the A/C compressor (4).
    6. Fig 2: Discharge Hose Nut & Condenser
    GM798938Courtesy of GENERAL MOTORS CORP.
  6. Remove the discharge hose nut (1) from the condenser (2).
  7. Remove the discharge hose (3) from the condenser (2).
  8. Remove the discharge hose (3) from the vehicle.
  9. Discard all of the used sealing washers.
  10. Cap all of the A/C system openings.
scientia non olet · About LEMON Manuals