LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Distributor Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Distribution Duct & Screws
    GM810854Courtesy of GENERAL MOTORS CORP.
  1. Install the air distribution duct (1) to the I/P trim Panel (2).
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the screws (3) to the air distribution duct (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 2: Screw & Air Distribution Duct
    GM870446Courtesy of GENERAL MOTORS CORP.
  3. Install the screw (1) to the air distribution duct (4).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  4. Install the I/P trim panel. Refer to Instrument Panel Upper Trim Pad Replacement .
scientia non olet · About LEMON Manuals