LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: A/C Refrigerant Pressure Sensor & Evaporator Tube
    GM1409917Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the A/C refrigerant pressure sensor.

    Tighten:  Tighten the switch to 6 N.m (53 lb in).

  2. Connect the electrical connector to the A/C refrigerant pressure sensor.
scientia non olet · About LEMON Manuals