LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 383 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Upper Intake Manifold Sight Shield Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Intake Manifold Sight Shield
    GM1696760Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Grasp the front of the intake manifold sight shield and lift up disengaging the grommets from the studs.
  3. Remove the intake manifold sight shield from the retainer slots.
    4. Fig 2: Manifold Sight Shield Retainer Bolts
    GM1696801Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold sight shield retainer bolts and retainer, if required.
scientia non olet · About LEMON Manuals