Installation Procedure
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the O-ring seal (421) with clean engine oil.
- Install a NEW O-ring seal onto the oil level indicator tube, if required.
- Install the oil level indicator tube (420) between the exhaust manifold and engine block.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Insert the oil level indicator tube into the block. The tube must be installed with the collar flush to the block.
- Lower the vehicle.
- Install the oil level indicator tube bolt (419).
Tighten
Tighten the bolt to 25 N.m (18 lb ft).
- Install the wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
- Install the oil level indicator (418).
CAUTION:
Refer to Fastener Caution .