LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 383 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Harness Electrical Connectors And Inlet Hose Clamp
    GM1697098Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement (RPOs LC9, LMG, LY5, L76) , Intake Manifold Replacement (RPOs LY2, LY6) , Intake Manifold Replacement (Except RPOs LY2, LY6, LC9, LMG, LY5) .
  2. Disconnect the engine harness electrical connector (1) from the oil pressure sensor.
    3. Fig 2: Oil Pressure Sensor
    GM1402008Courtesy of GENERAL MOTORS CORP.
  3. Using the J 41712 or equivalent, remove the oil pressure sensor (706) and washer (707).
scientia non olet · About LEMON Manuals