LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 382 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement

Stabilizer Shaft Link Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Stabilizer Shaft Link
GM1871116Courtesy of GENERAL MOTORS CORP.
Stabilizer Shaft Link Replacement

Callout Component Name
Preliminary Procedure 
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1 Rear Upper Stabilizer Shaft Link Nut
CAUTION:

Refer to Fastener Caution .


Tighten 
65 N.m (48 lb ft) plus 40 degrees
2 Rear Upper Stabilizer Shaft Link Bolt
3 Rear Lower Stabilizer Shaft Nut (Qty: 2)

Procedure

  1. Use an Allen wrench to keep the lower stabilizer shaft ball stud from rotating while removing the outer nut.
  2. When installing the inner stabilizer shaft link nut, ensure that it is tighten securely against the ball joint.

Tighten 
65 N.m (48 lb ft) plus 40 degrees
4 Rear Stabilizer Shaft
scientia non olet · About LEMON Manuals