LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 382 (Rear Suspension System) >> Repair Instructions >> Rear Axle Upper Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm.
    2. Fig 1: Upper Control Arm-To-Axle Bracket Retaining Nut And Bolt
    GM516271Courtesy of GENERAL MOTORS CORP.
  2. Install the upper control arm retaining bolt and nut to the axle bracket.
    3. Fig 2: Upper Control Arm-To-Frame Bracket Retaining Nut And Bolt
    GM516277Courtesy of GENERAL MOTORS CORP.
  3. Install the upper control arm retaining bolt and nut to the frame bracket.
    4. CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Do not tighten the nuts unless the suspension is at the curb height position.

  4. Tighten the upper control arm bolts to :
    • First Pass: 100 N.m (74 lb ft)
    • Final Pass: plus 55 degrees
  5. Connect the ESC sensor, if equipped. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side , or Electronic Suspension Rear Position Sensor Replacement - Right Side .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals