LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Park Brake) >> Repair Instructions >> Parking Brake Actuator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling 
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  4. Remove the rotor. Refer to Rear Brake Rotor Replacement .
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
  6. Remove the park brake shoe. Refer to Park Brake Shoe Replacement .
    7. Fig 1: Park Brake Actuator & Rubber Boot
    GM913342Courtesy of GENERAL MOTORS CORP.
  7. Remove the actuator (2) and rubber boot (1).
scientia non olet · About LEMON Manuals