LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Park Brake) >> Repair Instructions >> Parking Brake Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Actuator & Rubber Boot
    GM913342Courtesy of GENERAL MOTORS CORP.
  1. Install the rubber boot (1) and the actuator (2).
  2. Install the park brake shoe. Refer to Park Brake Shoe Replacement .
  3. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
  4. Adjust the park brake shoe. Refer to Park Brake Adjustment .
  5. Install the rotor. Refer to Rear Brake Rotor Replacement .
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  7. Remove the safety stands.
  8. Lower vehicle.
  9. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
scientia non olet · About LEMON Manuals