LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Park Brake) >> Repair Instructions >> Park Brake Shoe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the tire and the wheel. Refer to Tire and Wheel Removal and Installation .
  4. Remove the caliper and mounting bracket as an assembly. Refer to Rear Disc Brake Pads Replacement .
  5. Remove the rotor. Refer to Rear Brake Rotor Replacement .
    6. Fig 1: Cable, Lever & Backing Plate
    GM793127Courtesy of GENERAL MOTORS CORP.
  6. Remove the cable (3) from the backing plate (1) by compressing the spring to access and depress the locking tabs, pull the cable out of the backing plate, and routing the cable through the slot in the backing plate.
  7. Remove the cable (3) from the lever (2).
  8. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
    9. Fig 2: Park Brake Shoe Return Spring (1500HD/25/35 Series)
    GM370046Courtesy of GENERAL MOTORS CORP.
  9. Remove the park brake shoe return springs (4, 6).
    10. Fig 3: Park Brake Shoe Anchor Springs & Pins (1500HD/25/35 Series)
    GM913340Courtesy of GENERAL MOTORS CORP.
  10. Remove the park brake shoe anchor springs and pins.
  11. Remove the park brake shoes.
scientia non olet · About LEMON Manuals