LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Park Brake) >> Repair Instructions >> Park Brake Shoe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Park Brake Shoe Anchor Springs & Pins (1500HD/25/35 Series)
    GM913340Courtesy of GENERAL MOTORS CORP.
  1. Clean the debris and the dust from the park brake components using a clean towel.
  2. Install the park brake shoes.
  3. Install the park brake shoe anchor springs and pins.
    4. Fig 2: Park Brake Shoe Return Spring (1500HD/25/35 Series)
    GM370046Courtesy of GENERAL MOTORS CORP.
  4. Install the park brake shoe return springs (4, 6).
  5. Adjust the park brake shoe. Refer to Park Brake Adjustment .
  6. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
  7. Install the rotor. Refer to Rear Brake Rotor Replacement .
    8. Fig 3: Cable, Lever & Backing Plate
    GM793127Courtesy of GENERAL MOTORS CORP.
  8. Install the cable (3) to the lever (2).
  9. install the cable (3) to the backing plate (1) by compressing the spring, routing the cable through the slot in the backing plate and pressing the cable into the backing plate until the locking tabs snap into place.
  10. Install the caliper and mounting bracket as an assembly. Refer to Rear Disc Brake Pads Replacement .
  11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  12. Remove the safety stands.
  13. Lower the vehicle.
  14. Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
scientia non olet · About LEMON Manuals