Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the park brake release handle assembly to the vehicle. Install the cable using the same routing as the original cable.
- Install the park brake release cable to the pedal assembly.
- Install the park brake release cable housing to the pedal assembly.
- Install the MID-Bussed Electrical Center to the bracket.
- Install the park brake release lever handle to the knee bolster.
- Install the park brake release lever mounting bolt.
Tighten: Tighten the bolt to 25 N.m (18 lb ft).
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.