LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Park Brake) >> Repair Instructions >> Park Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Remove the left side hinge pillar panel. Refer to Body Hinge Pillar Trim Panel Replacement .
  4. Remove the MID-Bussed Electrical Center from the bracket.
    5. Fig 1: Park Brake Warning Lamp Switch Electrical Connector
    GM606395Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the park brake warning lamp connection.
    6. Fig 2: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the park brake release cable from the park brake lever.
    7. Fig 3: Park Brake Lever Mounting Nuts
    GM793126Courtesy of GENERAL MOTORS CORP.
  7. Remove the park brake lever mounting nuts.
    8. Fig 4: Front Brake Cable & Park Brake Lever
    GM913310Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the front park brake cable from the park brake lever.
  9. Remove the park brake lever.
scientia non olet · About LEMON Manuals