Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the front park brake cable to the park brake lever.
- Install the park brake lever.
- Install the park brake lever mounting nuts.
Tighten: Tighten the nuts to 25 N.m (18 lb ft).
- Connect the park brake release cable to the park brake lever.
- Connect the park brake warning lamp connector.
- Install the MID-Bussed Electrical Center bracket.
- Install the left side hinge pillar panel. Refer to Body Hinge Pillar Trim Panel Replacement .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.