Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 1: View Of Park Brake Cable & Equalizer

Courtesy of GENERAL MOTORS CORP.

Disconnect the right rear cable from the equalizer.

Fig 2: Left Rear Cable & Cable Support

Courtesy of GENERAL MOTORS CORP.

Remove the right rear cable (1) from the cable support (2).

Fig 3: Track Bar & Clips

Courtesy of GENERAL MOTORS CORP.

Remove the track bar clips (1) from the track bar.

Fig 4: Cable, Lever & Backing Plate

Courtesy of GENERAL MOTORS CORP.

Remove the cable (3) from the backing plate (1) by compressing the spring to access and depress the locking tabs, pull the cable out of the backing plate, and routing the cable through the slot in the backing plate.
Remove the cable (3) from the lever (2).

Fig 5: Left Rear Park Brake Cable

Courtesy of GENERAL MOTORS CORP.

Remove the right rear cable (3) from the cable guide (2).
Remove the cable from the vehicle.