Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the park brake cable guide to the park brake cable.
- Install the park brake cable guide (2).
- Install the park brake cable guide bolt.
Tighten: Tighten the bolt to 12 N.m (106 lb in).
- Remove the safety stands.
- Lower the vehicle.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.