LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Park Brake) >> Diagnostic Information and Procedures >> Park Brake Shoe Inspection

Park Brake Shoe Inspection

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Brake Dust Caution .
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rear brake caliper bracket with the rear brake caliper. Refer to Rear Brake Caliper Bracket Replacement .
  4. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement .
  5. Inspect and replace the park brake shoe and lining if any of the following conditions are found:
    • Excessive wear indicated by the park brake lining being worn down to the shoe
    • Brake lining cracking
    • Oil or fluid contamination of the brake lining
  6. Adjust the park brake shoe. Refer to Park Brake Adjustment .
  7. Install the rear brake rotor. Refer to Rear Brake Rotor Replacement .
  8. Install the rear brake caliper with the rear brake caliper bracket. Refer to Rear Brake Caliper Bracket Replacement .
  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals