LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 379 (Steering Linkage System) >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
  2. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
    3. Fig 1: Inner Tie Rods Ends
    GM865341Courtesy of GENERAL MOTORS CORP.
  3. Remove the steering linkage inner tie rod (1) from the relay rod using wrench J 34028  (2).
scientia non olet · About LEMON Manuals