LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 379 (Steering Linkage System) >> Repair Instructions >> Pitman Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to Steering Gear Replacement (Recirculating Ball Without LMM) , Steering Gear Replacement (Two Mode Hybrid) , Steering Gear Replacement (Hydraulic Rack and Pinion) .
  2. Place the steering gear into a vise.
    3. Fig 1: Pitman Arm Nut And Washer
    GM1862648Courtesy of GENERAL MOTORS CORP.
  3. Remove the pitman arm nut (1) and washer (2).
    4. Fig 2: Disconnecting Pitman Arm From Pitman Shaft
    GM398243Courtesy of GENERAL MOTORS CORP.
  4. Remove the pitman arm from the pitman arm shaft using puller J 6632-01  or puller J 29107-A .
scientia non olet · About LEMON Manuals