LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 379 (Steering Linkage System) >> Repair Instructions >> Idler Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION:

    Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.

  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
    2. Fig 1: Idler Arm, Bolts And Relay Rod
    GM1862657Courtesy of GENERAL MOTORS CORP.
    NOTE:

    Discard the idler arm nut.

  2. Remove the idler arm nut (3) from the idler arm (1).
  3. Separate the idler arm (1) from the relay rod (2).
    4. Fig 2: Separating Adjustment Link From Lower Control Arm
    GM643351Courtesy of GENERAL MOTORS CORP.
  4. Remove the idler arm from the relay rod using puller J 24319-B .
    5. Fig 3: Idler Arm, Frame Bolts And Nuts
    GM340442Courtesy of GENERAL MOTORS CORP.
  5. Remove the idler arm bolts (3) and the nuts (1) at the vehicle frame.
  6. Remove the idler arm (2) from the vehicle.
scientia non olet · About LEMON Manuals