LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 379 (Steering Linkage System) >> Repair Instructions >> Idler Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Idler Arm, Frame Bolts And Nuts
    GM340442Courtesy of GENERAL MOTORS CORP.
  1. Position the idler arm (2) to the vehicle frame.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the idler arm bolts (3) and nuts (1) to the frame and tighten to 105 N.m (78 lb ft).
    3. Fig 2: Idler Arm, Bolts And Relay Rod
    GM1862657Courtesy of GENERAL MOTORS CORP.
  3. Install the idler arm (1) to the relay rod (2).
    4. NOTE:

    Do not reuse the old idler arm nut.

  4. Install the new idler arm nut (3) to the idler arm (1) and tighten to 62 N.m (46 lb ft).
  5. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  6. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
scientia non olet · About LEMON Manuals