LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 378 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Rear Extension Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Cadillac Escalade EXT, 2011 Cadillac Escalade ESV, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Output Shaft Bushing
    GM1549538Courtesy of GENERAL MOTORS CORP.
    NOTE:

    Install the bushing with the notched area facing outward and properly aligned to the rear case. Oil pick up "slot" should be straight down in the vehicle.

  1. Using J 45380 install the output shaft bushing, if removed or new.
  2. Install the rear output shaft seal. Refer to Rear Output Shaft Seal Replacement .
scientia non olet · About LEMON Manuals