LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 378 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Cadillac Escalade EXT, 2011 Cadillac Escalade ESV, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
  4. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
  5. Drain the fluid from the transfer case.
  6. Support the transmission with a suitable jack stand.
  7. Fig 1: Transmission Mount Nuts
    GM647997Courtesy of GENERAL MOTORS CORP.
  8. Remove the transmission mount nuts and bolts.
  9. Fig 2: Crossmember And Bolts
    GM652595Courtesy of GENERAL MOTORS CORP.
  10. Remove the crossmember bolts.
  11. Remove the crossmember.
  12. Remove the transmission mount.
  13. Install a suitable transmission jack to the transfer case.
  14. Fig 3: Transfer Case And Transmission
    GM828574Courtesy of GENERAL MOTORS CORP.
  15. Remove the transfer case adapter nuts.
  16. Remove the fuel pipe bracket from the studs.
  17. NOTE:

    Pull straight back on the transfer case in order to position the transfer case so that it can be rotated parallel to the transmission.

  18. Remove the transfer case from the adapter.
  19. Rotate the transfer case so that it is perpendicular to the torsion bar mounting bracket.
  20. Lower the transfer case.
  21. Remove the gasket from the transfer case.
  22. Remove the transfer case from the transmission jack.