LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 378 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Adapter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Cadillac Escalade EXT, 2011 Cadillac Escalade ESV, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transfer Case Adapter, Bolts And Seal
    GM652614Courtesy of GENERAL MOTORS CORP.
    NOTE:

    Always use a new seal for the adapter. Do not use any type of sealant or adhesive in place of or with the seal.

  1. Install a NEW seal onto the adapter.
    2. NOTE:

    The transfer case adapter must be installed so that the adapter is evenly seated to the transmission before installing the retaining nuts.

  2. Install the adapter.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the adapter bolts.

    Tighten 

    Tighten the bolts to 50 N.m (37 lb ft).

  4. Install the transmission mount.
  5. Install the transfer case. Refer to Transfer Case Assembly Replacement .
scientia non olet · About LEMON Manuals