LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 375 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Drive Belt Tensioner Diagnosis

Drive Belt Tensioner Diagnosis

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Drive Belt Tensioner Diagnosis

Step Action Yes No
1 Remove the drive belt. Refer to Drive Belt Replacement - Accessory . Inspect the drive belt tensioner pulley.
Is the drive belt tensioner pulley loose or misaligned?		 Go to Step 4  Go to Step 2 
2 Rotate the drive belt tensioner.
Does the tensioner rotate without any unusual resistance or binding?		 Go to Step 3  Go to Step 4 
3
  1. Use a torque wrench in order to measure the torque required to move the tensioner off of the stop.
  2. Use a torque wrench on a known good tensioner in order to measure the torque required to move the tensioner off of the stop.
Is the first torque reading within 10% of the second torque reading?		 System OK Go to Step 4 
4 Replace the drive belt tensioner. Refer to Drive Belt Tensioner Replacement - Accessory .
Is the repair complete?		 System OK -
scientia non olet · About LEMON Manuals