Catalytic Converter Replacement (with Exhaust Clamp)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Catalytic Converter (With Exhaust Clamp)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the engine skid plate (if equipped). Refer to Oil Pan Skid Plate Replacement (1500 with RPO NZZ) , Oil Pan Skid Plate Replacement (2500/3500 with RPO NZZ) Remove the transmission support crossmember. Refer to Transmission Support Crossmember Replacement (4WD 2500 Series) , Transmission Support Crossmember Replacement (4WD 1500 Series) , Transmission Support Crossmember Replacement (2WD 2500 Series) , Transmission Support Crossmember Replacement (2WD 1500 Series) Remove the oxygen sensors. Refer to Heated Oxygen Sensor Replacement - Bank 1 Sensor 1 ,, Heated Oxygen Sensor Replacement - Bank 1 Sensor 2 ,, Heated Oxygen Sensor Replacement - Bank 2 Sensor 1 , and Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 .
1	Left Exhaust Manifold Nut (Qty: 3) WARNING: Refer to Exhaust Service Warning . WARNING: Refer to Hot Exhaust System Warning . CAUTION: Refer to Fastener Caution . Tighten 50 N.m (37 lb ft)
2	Seal
3	Right Exhaust Manifold Nut (Qty: 3) Tighten 50 N.m (37 lb ft)
4	Seal
5	Exhaust Muffler Clamp Nut TIP: Replace the exhaust muffler clamp with a NEW clamp. Tighten 28 N.m (21 lb ft)
6	Catalytic Converter