LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 373 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Rear Propeller Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the splines of the slip yoke for a sufficient coating of lubricant. If the splines of the slip yoke do not have a sufficient coating of lubricant, lubricate the shaft with lubricant GM P/N 12345879 (Canadian P/N 10953511) or with an equivalent lubricant meeting GM specification 9985830 (RWD w/4-speed Automatic Transmission).
    2. Fig 1: Propeller Shaft And Transmission
    GM404287Courtesy of GENERAL MOTORS CORP.
  2. Install the propeller shaft into the transmission or transfer case.

    Align the reference marks made during removal.

    3. Fig 2: Rear Propeller Shaft And Rear Axle Pinion Yoke
    GM361391Courtesy of GENERAL MOTORS CORP.
  3. Install the propeller shaft (3) to the rear axle pinion yoke (4).

    Align the reference marks made during removal.

    4. CAUTION:

    Refer to Fastener Caution .

  4. Install the NEW yoke retainers (2) and bolts (1) and tighten to 25 N.m (18 lb ft).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals