LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 373 (Propeller Shaft And Universal Joints) >> Diagnostic Information and Procedures >> Ping, Snap, or Click Noise

Ping, Snap, or Click Noise

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Ping, Snap, or Click Noise

Checks Action
DEFINITION: A ping, snap or click is usually heard on initial load after the transmission is in gear, either in forward or reverse.
A loose pinion yoke or companion flange. Tighten the bolts and the pinion nut to specified torque. Refer to Fastener Tightening Specifications .
One or more of the universal joints are worn or damaged. Replace the universal joint. Refer to the following:
Heat shield interference Eliminate interference.
scientia non olet · About LEMON Manuals