LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Front Drive Axle) >> Repair Instructions >> Vent Hose Replacement (8.6 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vent Hose And Connector At Shock Tower
    GM2527926Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose (1) from the connector (2) at the shock tower
    2. Fig 2: Vent Hose
    GM1690649Courtesy of GENERAL MOTORS CORP.
  2. Install the vent hose to the inner fender.
  3. Raise the vehicle.
    4. Fig 3: Vent Hose And Connector
    GM2527927Courtesy of GENERAL MOTORS CORP.
  4. Install the vent hose (1) to the frame connector (2).
  5. Install the vent hose to the connector.
  6. Install the oil pan skid plate, if equipped. Refer to Oil Pan Skid Plate Replacement (1500 with RPO NZZ) , Oil Pan Skid Plate Replacement (2500/3500 with RPO NZZ) .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals