LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Front Drive Axle) >> Repair Instructions >> Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Drain the differential carrier assembly. Refer to Front Axle Lubricant Replacement .
  3. Remove the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (2500) , Wheel Drive Shaft Replacement (1500) .
    4. Fig 1: Disconnecting Inner Axle Shaft - Front Drive Axle
    GM763648Courtesy of GENERAL MOTORS CORP.
    NOTE:

    If only replacing the right side inner shaft and/or housing, follow the steps below. If only replacing the left side inner shaft, proceed to step 10.

  4. Using a hammer and brass drift, disconnect the inner axle shaft from the differential case side gear.
    5. Fig 2: Front Drive Inner Axle Shaft Housing Nuts
    GM763653Courtesy of GENERAL MOTORS CORP.
  5. Remove the inner axle shaft housing nuts from the bracket.
    6. Fig 3: Inner Axle Shaft & Components
    GM1690932Courtesy of GENERAL MOTORS CORP.
  6. Remove the inner axle shaft housing bolts (2) from the differential carrier assembly.
  7. Remove the inner axle shaft (1) and inner axle shaft housing (4) from the vehicle.
  8. Remove the inner axle shaft housing gasket (3) from the inner axle shaft housing (4).
  9. Remove the inner axle shaft seal and the bearing from the inner axle shaft housing. Refer to Front Drive Axle Inner Shaft Seal and Inner Shaft Bearing Replacement (8.6/ 9.25 Inch Axle) .
    10. Fig 4: Inner Axle Shaft
    GM1581720Courtesy of GENERAL MOTORS CORP.
  10. Using a hammer and a brass drift, remove the inner axle shaft.
scientia non olet · About LEMON Manuals