LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Front Drive Axle) >> Repair Instructions >> Front Drive Axle Inner Shaft Seal Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Drive Axle Inner Shaft Seal
    GM2529101Courtesy of GENERAL MOTORS CORP.
  1. Position the NEW front drive axle inner seal (1) so that it is even in the front drive axle inner shaft housing.
    2. Fig 2: New Axle Shaft Seal - Front Drive Axle
    GM1486575Courtesy of GENERAL MOTORS CORP.
  2. Using the EN 44215  installer (2) and the J 8092  handle (1), install the front drive axle inner seal.
  3. Install the front drive axle inner shaft in the inner shaft housing. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement .
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals