LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Front Drive Axle) >> Repair Instructions >> Front Drive Axle Inner Shaft Seal Replacement - Left Side

Front Drive Axle Inner Shaft Seal Replacement - Left Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Drive Axle Inner Shaft And Seal
GM2523018Courtesy of GENERAL MOTORS CORP.
Front Drive Axle Inner Shaft Seal Replacement - Left Side

Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (2500) , Wheel Drive Shaft Replacement (1500) .
1 Front Drive Axle Inner Shaft
Procedure 
Using the J 45859  puller and the J 2619-4  slide hammer, remove the front drive axle inner shaft.
TIP:  It maybe necessary to have the aid of an assistant to hold the steering knuckle assembly to side in order to have enough access to the front drive axle inner shaft.

Special Tools

  • J 2619-4  Slide Hammer
  • J 45225  Axle Seal Installer

For equivalent regional tools, refer to Special Tools .
2 Front Drive Axle Inner Shaft Seal
Procedure 
Using the J 45225  installer and a soft face mallet, install the front drive axle inner shaft seal.
Special Tools 
J 45859  Puller