LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Front Drive Axle) >> Repair Instructions >> Front Axle Lubricant Level Inspection (8.25 Inch Axle)

Front Axle Lubricant Level Inspection (8.25 Inch Axle)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Make sure the vehicle is level.
  3. Inspect the front axle for leaks. Repair as necessary.
  4. Clean the area around the front axle fill plug.
  5. Fig 1: Front Axle Fill Plug
    GM1690153Courtesy of GENERAL MOTORS CORP.
  6. Remove the front axle fill plug (1).
  7. Inspect the oil level.

    Specification 

    The 8.25 inch axle the oil level should be between 12-16 mm (0.50-0.625 in) below the fill plug opening.

  8. If the level is low, add oil until the level is between 12-16 mm (0.50-0.625 in) for the 8.25 inch axle. Use the correct fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  9. CAUTION:

    Refer to Fastener Caution .

  10. Install the fill plug and tighten to 33 N.m (24 lb ft).
  11. Lower the vehicle.