LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement (8.25 inch) , Differential Carrier Assembly Replacement (4WD 1500 Hybrid) , Differential Carrier Assembly Replacement (9.25 inch) .
    2. Fig 1: Upper Differential Carrier Assembly Bushing And Special Tool
    GM893247Courtesy of GENERAL MOTORS CORP.
  2. Remove the upper differential carrier assembly bushing by performing the following steps:
    1. Install the J 36616-2 (1), the J 33791-1 (2), the thrust bearing (3), the J 21474-18 (4), and the forcing screw as shown.
    2. Remove the upper differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
    3. Fig 2: Lower Differential Carrier Assembly Bushing And Remover
    GM892847Courtesy of GENERAL MOTORS CORP.
  3. Remove the lower differential carrier assembly bushing by performing the following steps:
    1. Install the J 21474-18 (1), the thrust bearing (2), the J 33791-1 (3), the J 36616-2 (4), and the forcing screw as shown.
    2. Remove the lower differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
scientia non olet · About LEMON Manuals