Circuit/System Verification
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
- Ignition ON, verify the scan tool hood position parameter displays Open.
- If the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle for DTC P254F.
- Engine idling, verify there is no abnormal engine noise.
- If there is an abnormal engine noise, refer to Symptoms - Engine Mechanical .
- Observe the DTC information with a scan tool. Verify that DTC P0201-P0208, P0315, P0335, P0336, P0351-P0358 are not set.
- If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- A misfire may only occur when the engine is under load. An engine load may be necessary to verify the condition.
- Random misfires that are not steadily incrementing may be normal.
- Engine idling, observe the Misfire Current Cyl. 1-8 Counter parameters with a scan tool. The misfire current counter parameters should not be incrementing.
- Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
NOTE: