LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 370 (Engine Controls And Fuel - Hybrid (LZ1) - DTC P0010 Through DTC P0341) >> Diagnostic Information and Procedures >> DTC P0112 or P0113 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Engine idling, observe the scan tool IAT Sensor parameter. The reading should be between -38 to +149°C (-36 to +300F) depending on the current ambient temperature and the vehicle operating conditions.
  4. Operate the vehicle within the Conditions for Running the DTC to verify that the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals