Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice .

Fig 1: Button & Module Assembly

Courtesy of GENERAL MOTORS CORP.

Install the button and module assembly to the overhead console (1).

Fig 2: Garage Door Module Screws

Courtesy of GENERAL MOTORS CORP.

Align the module and screws into the overhead console.
Tighten: Tighten the screws to 8 N.m (70 lb in).

Fig 3: Connecting Individual Connectors To Garage Door Module

Courtesy of GENERAL MOTORS CORP.

Connect the individual connectors to the garage door module.

Fig 4: Overhead Console Screws (Short Length)

Courtesy of GENERAL MOTORS CORP.

Fasten the overhead console to the headliner.
Refer to Control Module References for programming and setup information.