LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0010 Through DTC P0442) >> Diagnostic Information and Procedures >> DTC P0341 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, inspect the camshaft position sensor for looseness and correct installation.
    • If the camshaft position sensor is loose, inspect the sensor and the O-ring for damage, and replace as necessary.
  2. Inspect the engine for the following conditions:
    • Engine oil for debris
    • Camshaft reluctor wheel for damage
    • The timing chain, timing chain tensioner, and sprockets for wear or damage
    • If debris is found in the engine oil, inspect the internal engine components to determine the cause. Repair or replace any worn or damaged components.
scientia non olet · About LEMON Manuals