LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0010 Through DTC P0442) >> Diagnostic Information and Procedures >> DTC P0107 or P0108 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTC P0641, or P0651 is not set.
  2. Ignition ON, observe the scan tool MAP Sensor parameter. The reading should be between 0.20-4.80 V.
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals