LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0010 Through DTC P0442) >> Diagnostic Information and Procedures >> DTC P0102 or P0103 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the MAF/IAT sensor.
  2. Ignition OFF, all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 5 Ω between the ground circuit terminal E and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the ignition voltage circuit terminal D and ground.
    • If the test lamp does not illuminate, test the ignition voltage circuit for a short to ground or an open/high resistance.
  4. Ignition ON, test for 4.8-5.2 V between the MAF sensor signal circuit terminal C and ground.
    • If less than the specified range, test the MAF sensor signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the MAF sensor signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Ignition OFF, connect the red lead of the J 38522 to the MAF sensor signal circuit terminal C at the MAF/IAT sensor harness connector. Connect the battery voltage supply to B+, and the black lead to ground.
  6. Set the J 38522 to the following specifications.
    • Signal switch to 5 V
    • Frequency switch to 5 KHz
    • Duty Cycle switch to Normal
  7. Engine idling, observe the scan tool MAF Sensor parameter. The reading should be between 4, 950-5, 050 Hz.
    • If not within the specified range, replace the ECM.
  8. If all circuits test normal, test or replace the MAF/IAT sensor.
scientia non olet · About LEMON Manuals