LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 369 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0010 Through DTC P0442) >> Diagnostic Information and Procedures >> DTC P0010 >> Component Testing >> Static Test

Static Test

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, remove the Camshaft Position Actuator Magnet.
  2. Test for 5.0-9.0 Ω between the solenoid control terminal 2 and the low reference terminal 1 at the Camshaft Position Actuator Magnet.
    • If not within the specified range, replace the Camshaft Position Actuator Magnet.
  3. Test for infinite resistance between each terminal of the magnet and the magnet housing.
    • If not the specified value, replace the Camshaft Position Actuator Magnet.
scientia non olet · About LEMON Manuals