LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 367 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0572 or P0573 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the stop lamp switch.
  2. Ignition ON, test for B+ between the B+ circuit terminal B and ground.
    • If less than the specified value, test the B+ circuit for a short to ground or an open/high resistance.
  3. Verify the BPP Circuit Signal data parameter displays released.
    • If not the specified value, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Connect a 3A fused jumper between the B+ circuit terminal B and the signal circuit terminal A. Verify the BPP Circuit Signal data parameter displays applied.
    • If not the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the stop lamp switch.
scientia non olet · About LEMON Manuals