LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Engine Controls And Fuel - Hybrid (LZ1) - DTC P0351 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> Service Bay Test >> Test Procedure

Test Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the Service Bay Test aborts or fails a DTC will NOT be set.

  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Select the Service Bay Test with the scan tool.
    4. WARNING:

    Refer to Road Test Warning .

  4. Follow the instructions on the scan tool.
    • If the test aborts, correct the condition for running the test and then retest.
    • If the test fails, repair the vehicle for the condition indicated by the failure message on the scan tool.
  5. Verify that the EVAP I/M system status is set to YES.
scientia non olet · About LEMON Manuals