LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Engine Controls And Fuel - Hybrid (LZ1) - DTC P0351 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> Malfunction Indicator Lamp (MIL) Diagnosis >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, command the MIL ON and OFF with a scan tool. The MIL should turn ON and OFF.
  2. Engine idling, command the MIL ON and OFF with a scan tool while observing the following control circuit status parameters:
    • MIL Circuit Short to Gnd Test Status
    • MIL Circuit Open Test Status
    • MIL Circuit Short to Voltage Test Status

      Each parameter should toggle between OK and Not Run or Not Run and OK.

scientia non olet · About LEMON Manuals