Circuit/System Verification
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
- Ignition ON, verify the scan tool hood position parameter displays Open.
- If the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle for DTC P254F.
- Engine idling, observe the EBCM DTC information with a scan tool. EBCM DTCs should not set.
- If a DTC sets, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- If there are no EBCM DTCs set, refer to the following:
- Symptoms - Antilock Brake System for the ABS - Hybrid
- Symptoms - Antilock Brake System for the ABS - Non-Hybrid Less than 3900 kg (8600 lb) GVW
- Symptoms - Antilock Brake System for the ABS - Non-Hybrid Greater than/Equal to 3900 kg (8600 lb) GVW
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
NOTE:
If an UXXXX DTCs are set, diagnose those first.