LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> Service Bay Test >> Test Procedure

Test Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If the Service Bay Test aborts or fails, a DTC will NOT be set.

  1. Select the Service Bay Test with the scan tool.
    2. WARNING:

    Refer to Road Test Warning .

  2. Follow the instructions on the scan tool. The EVAP test should pass and should not abort.
    • If the test aborts, correct the condition for running the test, then retest.
    • If the test fails, repair the vehicle for the condition indicated by the failure message on the scan tool.
  3. Verify that the EVAP Inspection/Maintenance system status is set to YES.
scientia non olet · About LEMON Manuals